MAGvault^TM Weapons vaults and armories
Approved for military use DoD 5100.76M, AR 190-11, and OPNAVINST 5530.13C

MAGvault Home        MAGvault Design

Standard Features

• 1/4" Plate Steel Exterior A-36 exterior / 2" kiln dried hardwood / insulation / and a 5/8" finished plywood interior
• Hardened high security door, with A-36 HRS pins for hinge side protection
• NAPEC high security hasps and cam closure for weather tight seal.
• Interior Dutch Door with Day/Issue Port
• Door water trap
• VCT Floor Tile
• All conduit runs and make-up boxes for IDS system
• Exterior electrical service entrance, IDS service entrance, telephone enclosure
• HVAC system with Vent Hardening
• Roof Lifting Lugs and tie-down rings
• All associated electrical devices and exterior/interior lighting
• NFPA grounding kit, grounding lugs and grounding rods (two each per item)

The armory is activated by an electrical connection to the load center and ground rod installation by the customer.

Optional accessories are available upon request for customers meeting specific requirements. Including:

• Humidity Control by means of a commercial grade dehumidifier with plenum works (it is suggested that arms and ammunition be stored in an environment no greater than 40% relative humidity).
• Weapons Racks, Storage Cabinets, Ammunition Storage Cabinets and Personnel Desk
• High density mobile aisle systems
• Furnishing and wiring of the IDS system
• Work Benches and Weapons Maintenance Bench
• Smoke Alarm with exterior horn/strobe 
• Dry Chemical Fire Suppression System / Wet Sprinkler System
• weapons clearing barrel system,exterior mounted only
• Interior Cage Partition Walls with locked access door
• Secondary entrance/exit door
• Increased insulation for heating/cooling systems (standard Armory insulation is R4; we suggest using no less than R12)
• Ramps
• Back-up Emergency Lighting for interior and exterior service
• Non-standard voltage systems (standard is 120V/1/60)
• Toilet facility(usually furnished only in duplex armories
• Lighting package (roof grid system, air terminals and four corner downward connector)
• Special bullet-resistant requirements
• Freight, Crane, Rigging and Installation

Pre-fabricated / Pre-engineered portable self contained field armories are constructed to be fire-resistant, weather-resistant and theft-resistant.  These armories are designed to store small arms and ready for issue small arms ammunition.  These armories meet or exceed DOD NSWC 3046-93-2 standards.